![]() ![]() ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ Keep the whole world singing. fix bubbles in drywall tape how to fix a bubble in drywall tape hunker apply mud over the spot and also on both sides of the tape use the knife to smoothen. A few holes in the tape are no different than similar holes in the face paper of the rock. plastic/paper mailers and paper bubble wrap envelopes. Check out our article Drywall Damage Patch & Repairs for. beverage cans bicycles or bike parts blister packages boat bottle caps and jar lids. Then attach the drywall and use a good-quality drywall tape to cover the seams. ![]() You may have to back it with a piece of plywood. Cut a new piece of drywall to fit tightly into the hole you have created. If it is generalized, you would probably be ahead to just pull off anything that is loose and start over. Set up a fan near the hole you created and thoroughly dry the area before continuing. If it is a limited area, I would try some spot repair. The bubble happens because there was not enough mud to coat the underside of the tape. ![]() It sound like you may have a slightly starved joint between two sheets. Now is the time to fix any portions that are not. Experience helps here, but now is the time to study the edges of the tape to see that they are well stuck to the drywall with a full wet coat of compound under the tape. As you wipe the tape in, the excess mud will ooze out from under the tape you continue wiping and squeezing the joint until the tape lays flat and the edges of the taping mud are feathered tight to the wall (you do not want to squeeze all the compound out from under the tape, you are trying to bed the tape in compound). If it were brand new work, you would fill the joint with well blended compound, place the paper tape over the joint, and wipe in with your knife. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |